Der Isolationswiderstand von Draht- und Kabelprodukte misst hauptsächlich den Durchgangswiderstand der Kabelisolationsschicht, Der Oberflächenwiderstand kann nicht gemessen werden, und weitere Faktoren beeinflussen den Wert des Kabelisolationswiderstands. In der praktischen Anwendung, Es gibt vier Hauptfaktoren für den Isolationswiderstandskoeffizienten.
1. Temperature influence:: As the temperature increases, the insulation resistance decreases due to the increase in thermal movement and the increase in ion generation and migration. Under the action of voltage, the conduction current formed by ion movement increases, so the insulation resistance decreases. Theory and practice show that the insulation resistance coefficient decreases exponentially with the increase in temperature, while the conductivity increases exponentially with the increase in temperature.
2. Electric field strength effect: when in the low range, the electric field strength so that the ion mobility increases with the electric field strength, ion current and electric field strength obey Ohm’s law. When the electric field strength is higher, the ion mobility increases with the electric field strength, the trend gradually changed from a linear relationship to an exponential relationship, when close to breakdown will have numerous electron migration. Zu diesem Zeitpunkt, the insulation resistance factor is greatly reduced.
3. Humidity effects: due to the small electrical conductivity and the size of the water molecules are much smaller than the polymer molecules. Under the thermal effect of polymer macromolecules and the relative motion of the chain links, water molecules easily penetrate the polymer. To make the polymer conductive ions increase, insulation resistance decreases.
4. Material purity impact: the material is mixed with impurities, increasing the conductive particles in the material so that the insulation resistance decreases. Deswegen, the size of the insulation resistance of rubber and plastic materials will reflect the purity of the material, to verify whether it meets the standard provisions. In the production process of wire and cable, not strictly comply with the process operating procedures, mixed with impurities, material moisture blistering, insulation part of the core or outside diameter size less than the standard provisions, cracks in the insulation layer or insulation scratches, usw., will make the insulation resistance of the product is reduced. Deswegen, it is necessary to check the insulation resistance during operation to check whether there are problems. During the use of Draht und Kabel, measuring the change of insulation resistance can also check the damage to insulation and prevent accidents from occurring.
